A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
Stopping the water source is priority one before any extraction begins.
We use pressure testing and moisture tracing to locate exactly where a supply line failed inside the wall.
We open wall cavities in a controlled, targeted way based on documented moisture data.
We coordinate directly with a licensed plumber for the actual pipe repair once our mitigation work is done.
Here's the full scope of a burst pipe response in Gateway.
Stopping active water flow happens before any cleanup step.
Diagnostics narrow down the exact wall section affected.
We extract from within the cavity itself, not just the surface that's visible.
Targeted removal limits the repair scope to what's actually necessary.
We dry wall framing directly, not just the room's ambient air.
Our Gateway, FL team can refer or work alongside a plumber so mitigation and repair stay on the same timeline.
We'll walk you through locating the shutoff valve over the phone if needed.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
We diagnose the leak location and provide a written estimate for extraction and drying before removal begins.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
No, we remove drywall only at the confirmed wet line based on moisture readings.
Pipe repair is handled by a licensed plumber we coordinate with, while we manage extraction and drying.
Turning off the water source, if accessible, limits damage before we arrive.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
Gateway sits within our core burst pipe response zone.
Speak directly with our burst pipe response team.
Call +1-844-578-1604